Systems for Ink Processing

Blending Specialty Inks for Food Packaging
Tank/Mixer Assembly
Series 3040, Model DRAM-C-300B-60C-SS
Mixer, Bridge Mounted, Through The Roof, Fixed Speed

Features

• Motor: 30 HP, 1750 rpm, 230/460V, 3-phase, Expl. Proof
• Drive: Falk Right Angle
• Mixer Reducer: 45 HP Thermal
• Mixer Shaft Speed:  100 rpm, nominal
• Outboard Bearing: 3 ½" ID, Thrust
• Mixing Shaft:  3 ½" dia. SS304
• Turbine, Mid:  42" dia, Type AFF
• Turbine, Bottom:  56" dia, Type VHE
• Bridge: 8" WF 30# Posts, 10" WF 30# Horiz.
• Roof Seal: Flashing & Counter-Flashing
• Tank (In Place): 6K Gallon, SS304, Heated, Insulated, Insulation Skin

Dispersing Microelectronics Film Inks
Disperser, Bridge Mounted
Series 3081, Model TVF-500-60-SS
Variable Frequency Drive

Motor Data: 50 HP, 1750 RPM, 230/460V, 3-phase, TEFC, Inverter Duty

Drive: Belt, 1:1 ratio, variable speed

Mix. shaft speed: 900 to 1700 nominal with operating frequency range 30 to 60 Hz

Controller: Variable Frequency Inverter (VFI), NEMA 1 enclosure

Shaft Seal: Teflon Disk

Bridge: 6" WF 12# heavy duty, disperser support over tank

Mixing Vessel: Polypropylene, 1100 gallon,cone bottom, steel support

Site Installation and Validation (as shown)

Processing Fast Drying Inks
Disperser/Mixer/Jacketed Reactor
Series 4020
Tank Mounted, Dual Motors, Dual Shafts, Half Pipe Jacket

This assembly is made of stainless steel and it is suitable for dispersing and mixing materials with viscosity in excess of 100,000 centipoise (cps) that tend to hang to the wall of the mixing vessel, thus assuring product uniformity and even batch circulation. Certain products require heating for improving the chemical reactions as it is in this case where the product is being heated using hot oil pipe jacket on the outside of the vessel. The high speed blade with a variable speed range of 400 to 1600 rpm will disperse the materials at a tip speed of 5200 feet per minute, while the large open type turbine, rotating in the range of 300 to 1300 feet per minute, will keep the high viscous materials flowing from the side wall and bottom to the disperser blade. Special engineered seals and charging hatches would make this assembly useful for vacuum/pressure applications. The drive system of the dual motors assembly may be supplied in single speed, dual speed, mechanical variable speed or electronic variable speed (variable frequency inverter) with standard TEFC or explosion proof motors. Motor starters and controls, ammeter and tachometers (analog or digital), temperature probes and indicators, glass view-ports, sight light view-ports, may be supplied as accessories. All controls and instrumentations for this assembly may be supplied in standard or explosion proof enclosures.